California Instruments 801RP Series Uživatelský manuál stáhnout pdf (Strana 10)

AMETEK Programmable Power MX / RS Series SCPI Programming Manual

10 MX / RS Series

1. Introduction

This manual contains programming information for the MX Series I and MX Series II and RS

Series AC/DC Power Sources. This manual contains the following chapters:

Chapter 1 Introduction

Chapter 2 Introduction to SCPI

Chapter 3 System Considerations and Interface Setup

Chapter 4 SCPI Command Reference

Chapter 5 Common Commands

Chapter 6 Programming Examples

Chapter 7 Status Registers

Chapter 8 Option Commands

Appendix A

SCPI command tree.

Appendix B SCPI conformance information.

Appendix C Error messages

1.1 Documentation Summary

This SCPI programming manual covers the California Instruments MX Series I and MX

Series II and RS Series AC/DC power sources. A separate User Manual is also supplied

with all models in this product series. For front panel operation and general service and

calibration information on these produces, please refer to the User Manual. The

programming manual covers issue related to operating the MX Series I or MX Series II or

RS Series remotely using an instrument controller.

The following documents are related to this Programming Manual and contain additional

helpful information for using these products in a remote control environment.

• User Manual . Includes specifications and supplemental characteristics, how to use the

front panel, how to connect to the instrument, and calibration procedures. Distributed on

the same CD as the programming manual.

1.2 Model Series I and Series II and RS Series

There are two versions of the MX Series product, Series I and Series II. This user manual

covers both MX model series with top level assembly part numbers 7003-400 (Series I),

7003-422 or 7003-427 (Series II), or 5440001 (RS Series) and 7005-400 (MX15 Series).

The difference between the Series I and the Series II is the controller used. The Series II

uses a newer controller design but retains as much backward compatibility with the Series I

products as possible. The part number is shown on the model / serial number tag on the

back of the MX/RS series. All Series II and RS Series will have a firmware revision of 4.0 or

higher. The firmware revision is displayed briefly at power up on the LCD display and can

also be queried over the bus by using the *IDN? command. The MX15 Series uses the

Series II controller, but firmware revisions do not start at 4.0 but rather at 0.6.

Differences between the two model Series I and Series II are:

• Reduced number of measurement calibration coefficients on Series II.

• Increased measurement sampling rate on Series II.

• Maximum DC offset range in AC+DC mode is 250Vdc on Series I, 220Vdc

on Series II

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 222 223

Komentáře k této Příručce

Žádné komentáře

California Instruments 801RP Series Uživatelský manuál Strana 10

Komentáře k této Příručce

Související produkty a manuály pro Měření, testování a kontrola California Instruments 801RP Series