California Instruments 801RP Series Uživatelský manuál stáhnout pdf (Strana 145)

MX / RS Series SCPI Programming Manual AMETEK Programmable Power

MX / RS Series 145

6.4 Programming Output Transients

Output transients are used to:

• Synchronize output changes with a particular phase of the voltage waveform.

• Synchronize output changes with internal or external trigger signals.

• Simulate surge, sag, and dropout conditions with precise control of duration and phase.

• Create complex, multi-level sequences of output changes.

• Create output changes that have rapid or precise timing requirements.

The following AC/DC source functions are subject to transient control:

• AC output voltage

• DC output voltage

• Frequency

• Start phase angle

• AC/DC voltage slew rate

• Frequency slew rate

The following transient modes can be generated:

Step generates a single triggered output change.

Pulse generates an output change which returns to its original state after some

time period.

List generates a sequence of output changes, each with an associated dwell

time or paced by triggers.

Fixed turns off the transient functions, which means that only the IMMediate

values are used as the data source for a particular function.

After a *RST or Device Clear command, all functions are set to FIXed, which turns off the

transient functions.

1 2 ... 140 141 142 143 144 145 146 147 148 149 150 ... 222 223

Žádné komentáře

California Instruments 801RP Series Uživatelský manuál Strana 145